mdsh.com/wiki

RaspberryPi @Dec 6, 2015 10:15:11 AM

• Broadcom SoC BCM2835
• ARM1176JZFS (ARMv6 architecture) 700MHz processor
• 256 or 512MB RAM (depending on board/revision)
• 1x SDHC slot
• 2x USB 2.0 port (for adding USB peripherals)
• various GPIO pins
• miniUART for serial comms
• optional additional HD camera board

See also: RaspberryPi 2, RaspberryPi Zero

Making a TP-LINK TL-WDN3200 WiFi Dongle work with RT5572 drivers

Connect from Mac to USB serial connected to RPi

screen /dev/tty.usbserial-FTGC9B77 115200

$ sudo vi /etc/network/interfaces
auto lo
iface lo inet loopback

auto eth0
iface eth0 inet dhcp

Use a WiPi

$ sudo vi /etc/network/interfaces
auto wlan0
iface wlan0 inet dhcp
wpa-ssid "ssid"
wpa-psk "password"

If you want to create a WiPi hotspot

$ sudo vi /etc/network/interfaces
allow-hotplug wlan0
iface wlan0 inet static
address 10.64.115.254
network 10.64.115.0
netmask 255.255.255.0

$ sudo vi /etc/hostapd/hostapd.conf
interface=wlan0
driver=nl80211

ssid=<SSID>
hw_mode=g
channel=1

macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0
wpa=2
wpa_passphrase=<PASSPHRASE>
wpa_key_mgmt=WPA-PSK
wpa_pairwise=TKIP
rsn_pairwise=CCMP

Connecting a 3G modem

• Connecting an MF627 3G USB modem

---

* Broadcom SoC BCM2835 * ARM1176JZFS (ARMv6 architecture) 700MHz processor * 256 or 512MB RAM (depending on board/revision) * 1x SDHC slot * 2x USB 2.0 port (for adding USB peripherals) * various GPIO pins * miniUART for serial comms * optional additional HD camera board See also: [[RaspberryPi 2]], [[RaspberryPi Zero]] !Making a TP-LINK TL-WDN3200 WiFi Dongle work with [[RT5572]] drivers! !Connect from Mac to USB serial connected to RPi! {{{__screen /dev/tty.usbserial-FTGC9B77 115200__}}} {{{__$ sudo vi /etc/network/interfaces__}}} {{{__auto lo iface lo inet loopback auto eth0 iface eth0 inet dhcp__}}} !Use a WiPi! {{{__$ sudo vi /etc/network/interfaces__}}} {{{__auto wlan0 iface wlan0 inet dhcp wpa-ssid "ssid" wpa-psk "password"__}}} !If you want to create a WiPi hotspot! {{{__$ sudo vi /etc/network/interfaces__}}} {{{__allow-hotplug wlan0 iface wlan0 inet static address 10.64.115.254 network 10.64.115.0 netmask 255.255.255.0__}}} {{{__$ sudo vi /etc/hostapd/hostapd.conf__}}} {{{__interface=wlan0 driver=nl80211 ssid=<SSID> hw_mode=g channel=1 macaddr_acl=0 auth_algs=1 ignore_broadcast_ssid=0 wpa=2 wpa_passphrase=<PASSPHRASE> wpa_key_mgmt=WPA-PSK wpa_pairwise=TKIP rsn_pairwise=CCMP__}}} !Connecting a 3G modem! * Connecting an [[MF627]] 3G USB modem